Абстрактный: Laser cladding, as an advanced surface treatment technology, significantly improves material properties such as hardness, strength, and wear resistance. The process parameters have a notable effect on the quality of the cladding layer, which can dramatically alter the results of laser cladding. This article briefly outlines how process parameters influence the laser cladding technique.

Process Parameters and Their Impact on Laser Cladding

В лазерная наплавка experiments, both heating and cooling occur very rapidly in a short time frame. Many factors can have a significant impact on this technology, such as laser power (P), spot size (beam diameter D), scanning speed (V), preset thickness, and powder feed rate. The quality of лазерная наплавка is often improved by adjusting the following three key process parameters:

1. Laser Power (P)

The laser power determines the power density of the laser beam. As the laser power increases, the power density of the laser beam increases, which leads to deeper cladding layers and higher molten pool temperatures. This can cause some powders to “vaporize.” Additionally, excessive power can cause the substrate to heat up too much, leading to cracking and other undesirable outcomes, ultimately affecting the quality of the cladding. Therefore, the laser power should not be too high, nor should it be too low. Using too low a power may result in incomplete melting of the material, leading to voids and poor quality. Selecting the proper laser power is crucial for achieving optimal results in лазерная наплавка.

2. Laser Spot Diameter (D)

The laser spot is generally circular, and variations in the spot size affect the energy distribution of the laser beam. A smaller spot diameter typically results in better cladding quality. However, as the spot diameter increases, the quality of the cladding layer tends to decrease. Thus, it is important to select the correct spot diameter to achieve optimal cladding performance with лазерная наплавка.

3. Scanning Speed (V)

Scanning speed influences several aspects of the cladding process, including the appearance, hardness, and wear resistance of the cladded layer. If the scanning speed (V) is too fast, the laser will have insufficient contact time with the powder, causing the powder to fly off the molten pool. The molten pool temperature will be too low, leading to incomplete melting of the alloy, which will degrade product quality. On the other hand, if the scanning speed is too slow, the molten pool temperature will become excessively high, leading to over-melting of the powder and a loss of alloy elements. Additionally, the elevated substrate temperature can result in more deformation. Therefore, selecting the appropriate scanning speed is essential to maintaining high-quality лазерная наплавка.

Заключение

Лазерная наплавка is an innovative surface improvement technology where a metallurgically bonded coating is formed on the material’s surface using a laser. This method significantly enhances material performance. The process parameters of лазерная наплавка greatly influence the quality of the cladded layer. Adjusting these parameters before performing лазерная наплавка is crucial, as it can significantly impact the results. Properly selecting the process parameters before starting лазерная наплавка ensures optimal outcomes for the experiment.